How Is The Geared Motor Connected To The Output Shaft?

The worm gear reducer is a power transmission mechanism. At present, the connection between the output shaft of the traditional worm gear reducer and the worm gear reducer is mainly through manual installation; then how to connect the geared motor to the output shaft? The following Vshda micro-motor will give you a brief introduction.

The manual installation method is too cumbersome and the equipment adopts this installation method to have strict tolerance requirements on the output shaft. If the diameter is too large, it will cause the installation to fail. If the diameter is too small, it will cause the installation to fail. It is very cumbersome, even difficult to disassemble, and the locking force after installation cannot be achieved. There is a slight gap between the output shaft and the worm gear reducer, which will increase the wear of the equipment, reduce the service life of the equipment, and reduce the quality of work. Therefore, various transmission mechanisms such as couplings, chains, and synchronous pulleys can be used to connect.

If it is a servo motor, it can be connected in the following two ways.
1. Connect by way of external coupling. A servo motor with a keyway is required. This connection method uses an external coupling and a flexible coupling (flexible shaft). The driving power of the flexible shaft generally does not exceed 5.5KW, and the speed can reach 20,000 rpm.

2. The output shaft of the servo motor extends into the reducer, and the servo motor and the reducer are connected through a flange. There is a deformable hoop inside the reducer. By operating the locking screw on the reducer, the hoop can connect the shaft of the servo motor.

The above is the method we shared with you about how to connect the geared motor to the output shaft. For more information, please contact us, and professional engineers will provide you with solutions.